Page 3
For technical questions, please call 1-888-866-5797.
Item 63729
Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the
beginning of this document including all text under subheadings therein
before set up or use of this product.
Assembly
1. Slide the plain end of the
Slide Hammer (12) onto Spindle (11).
2. Thread Lock Nut (3) onto threaded end
of Spindle (11), hollow side first.
It serves as a Hammer Stop
for the forward motion of the
Slide Hammer (12).
3. Insert Cross Bar (9) into eyelet
at the end of the Spindle.
Lock Nut
(3)
Spindle
(11)
Slide Hammer (12)
Cross Bar (9)
Figure A
Pulling Operation (Hub/Axle/Drum)
1. Raise the vehicle according
to its service instructions.
Safely support the vehicle on lift
or jack stands (not included).
2. Remove the wheel and tire and any
nuts, bolts or accessories (such as
brake calipers) that may get in the
way of removing the Hub/Axle/Drum.
3. Bolt the Rear Axle Puller (2) onto the
Hub/Axle/Drum using the original lug
nuts. If your vehicle has a four-bolt Hub,
match the Rear Axle Puller to two axle
bolts. If it has a five-bolt Hub, match to
three axle bolts. Tighten the lug nuts.
4. Thread the Spindle into the Rear Axle
Puller hub until its non-threaded end
exits the hub. Turn the Lock Nut (3)
forward until it seats against the
Rear Axle Puller hub and hand tighten.
Rear Axle Puller (2)
Slide Hammer
(12)
Figure B
5. Push the Slide Hammer towards the
work piece, and then forcefully pull
it back towards the cross bar end.
Repeat and adjust force as needed.
