Taurus LAN User Guide
Rebuilding a RAID array
When using RAID 1 and one of the drives has failed, the faulty HDD has to be replaced
and the RAID 1 array rebuilt.
1. Login and go to the RAID Setting menu to check the disk status. If there is a
problem, it will show which drive has to be replaced.
2. Turn off the power, remove the power supply from the wall socket and replace the
defective HDD with a new one.
3. Turn on the power and go to the RAID Setting menu. Press the “Add disk” button to
start rebuilding your RAID array.
Note: On the bridge board of your Taurus LAN, the connector at P1 indicates the drive at
hdb, whereas P2 indicates the drive at hda. With firmware v2.6.3 or later, P1 indicates the
drive at hdc and P2 the drive at hdd.
Page 26 / Chapter 3 - Web Configuration
