Please
read the Assembly
and
Troubleshooting Tips
at the
end of this instruction booklet before assembling elements.
8
0 TUBING
(TI IP)
O.D. TUBING
BLACK PLASTIC CAP
2” U-BOLT (UO I)
SADDLE
Ii
LOCKWASHERS
I
H E X N U T
FIGURE 3
ELEMENT ASSEMBLY AND MOUNTING
Select a frequency in the center of where you work from the chart on page 6 and follow across for
element dimensions “A”
To assemble the elements, slide a piece of
O.D. tubing
into each
slotted end of the
O.D. center section
Allow equal lengths on each end to arrive at the specified
overall length (Dimension “A”) as shown in Figure 3B. Be Accurate! Verify the overall length.
Slide a boom-to-mast mount
to the center of each element before securing the joints with
clamps and hardware as shown in Figure 3A.
Install elements on boom per dimensions in Figure with U-bolts, saddles, and hardware as shown
in Figure 3B. Be accurate as possible, and be sure the elements are exactly centered on boom before tightening
clamps.
4
