Mpression Helio Board
10
Getting Started - Mpression Helio Board
© Mpression by Macnica Group
4.2
Running Linux
This section presents how to run the pre-build Linux images on the Helio board.
1.
Setup the board as described in 2 Board Settings section.
2.
Setup the SD card as described in 3 Creating MicroSD boot disk for Helio Board Section.
3.
Connect a serial terminal from host PC to the serial port corresponding to UART USB
connection, and use appropriate settings described in [4.1.2 Setup Terminal Software].
4.
Power up the board using PWR switch
5.
After successful boot, Linux will ask for the login name. Enter root and press Enter:
Have fun!!
Figure 4-2 Linux boot log
