SK110 Issue 8 © 2017
Page 3 of 4
Troubleshooting Guide
Product Specifications
Maintenance Procedures
Do not attempt to remove the spring canister nuts.
(Located under the nuts that hold the spring canister in
place)
CAUTION
9) Feed the hose through the hose guide, fit the hose
stopper, then unlatch the drum and allow the hose
slowly to retract
TROUBLE
CAUSE
REMEDY
Hose w ill not fully retract
A) Outlet nozzle, gun or tool is too heavy
A) Add spring tension. See " Adjust Spring Tension"
B) Spring is fatigued
B) Add spring tension. See " Adjust Spring Tension" Replace Spring canister if
required, see "Replacement of Spring Canister"
C) Replacement hose is to long
C) Fit correct length hose (Refer Hose to specifications)
Hose w ill not retract at all
A) Spring has broken or has lost all tension
A) Replace Spring canister. See "Replacement of Spring Canister"
Reel will not latch
A) Incorrect operation
A) Reel latches on first second or third "click". After the third click the reel
automatically rewinds
B) Latch assembly is worn.
B) Replace the latch assembly
Fluid leaks from the swivel
A) Swivel seals are worn
A) Replace swivel seals. See " Replacement of Swivel Seals".
Model
Description
Reel
Reel Inlet
Hose Outlet Max Operating
Weight
I.D
Length
Max Working
Pressure
colour
Thread Size
Temperature
MAS1020
AIR
3/8" (10mm)
20m
300 PSI
Blue
3/8" BSP
3/8" BSP
60°C
21/23 kg
MAS1220
AIR
1/2" (12.5m
m)
20m
300 PSI
Blue
1/2" BSP
1/2" BSP
60°C
21/23 kg
MOS1220
OIL
1/2" (12.5m
m)
20m
1000 PSI
Blue
1/2" BSP
1/2" BSP
100°C
21/23 kg
MGS0615
GREASE 1/4" (6mm)
15m
5000 PSI
Blue
1/4" BSP
1/4" BSP
100°C
21/23 kg
Hose Specifications
1) Remove the hose stop and allow the drum to
release all its tension with the hose on the spool.
2) When there is no tension on the spring, the main
axle nut on the pedestal side can be released and
the drum with hose removed exposing the latch pawl
and its associated components.
3) To re-tension after any repairs have been made
and after the drum has been reassembled to the
pedestal, follow the “
Adjust Spring Tension
”
instruction.
5) Remove the top four nuts ONLY located on the
support post side or the drum.
4) Remove the swivel, circlip and spacer.
3) Carefully unlatch the reel and firmly hold the drum.
Allow the drum to slowly unwind until it stops.
6) Pull the spring canister off the drum shaft.
7) Reverse the above procedures to re-assemble.
REPAIR LATCH PAWL
8) Re-tension the reel by turning the drum three
complete turns clockwise (from the swivel side) and
latch the drum.
