E2
TECHNICAL
DETAILS
SAFETY
PRECAUTIONS
LIMITED
WARRANTY
EXPLODED AND
PARTS LIST
INSTALLATION INSTRUCTIONS
OPERATION
INSTRUCTIONS
STRUCTURE FEATURES
(2) Remove side cover and guide arm.
(3) Rotate guide roller bracket to correct position, replace bolts and tighten.
3. Using the four holes in the base, mount the reel in the desired location. Be sure to use appropri-
ate hardware and tighten securely.
4. Apply Teflon tape or pipe sealant to supply line threads, attach to reel inlet and tighten. The
other end of incoming line can now be connected to desired supply source.
5. If hose has been supplied with reel: Apply Teflon tape or pipe sealant to outlet fitting on reel
hose, then attach to desired tool, or nozzle. Check connection for leakage, also check hose
reel for correct operation. (Details see Operation section.)
6. If hose stopper adjustment is required, pull hose from reel and allow to latch at desired
length. Loosen stopper bolts and slide stopper to a position close to the hose guide. Tighten
stopper bolts, and unlatch the reel.
OPERATION INSTRUCTIONS
1. When you want to use the hose, pull out the hose slowly to the desired length and release it.
The hose may be retracted by a small section (about 10-15m) and get into a locked status
for use.
2. When you want to retract the hose, pull the hose out about 4cm (1.6in) and release it. The
hose can be retracted to the hose reel.
3. There is a slow retraction device installed on the hose reel. When the hose is in the
retraction state, the slow retraction device will have a deceleration effect, which can
significantly reduce the retraction speed of the hose (the longer the length of the retracted
hose, the more obvious the deceleration effect), and ensure the operation safety of the hose
when it is retracted.
4. Periodically check the hose condition for wear or damage, and check the swivel fitting for
leakage. Replace any worn, damaged, or leaking parts.
Hose Replacement
1. Turn off air supply to reel and carefully release pressure in hose.
2. Securely stabilize the reel by mounting or clamping to work surface.
3. Pull out all the old hose and lock the reel in this position.
Caution: Make sure reel drum is securely locked by letting ratchet teeth engage.
Replacement of Hose (continued)
4. Remove the two hose clamps connecting the hose to the reel.
5. Carefully disconnect hose from the swivel joint on the side of the reel and discard old hose.
6. Feed new hose through guide and opening in drum, use sealant and connect to swivel.
Reuse hose clamps on inside and outside of drum flange to reconnect hose.
7. Securely install stopper on other end of hose in the same position as before. Adjustments
can be made later.
SPRING CANISTER WARNING
If the rewind spring fails for any reason: For safety reasons, the manufacturer strongly
recommends the replacement of the spring canister be carried out by a professional mechanic.
Floor
Ceiling
Wall
