• Follow the Pressure Relief Procedure if the dispensing valve clogs before you clean, check or
service the equipment.
• Tighten all fluid connections before operating the equipment.
• Check the hoses, tubes, and couplings daily. Replace worn or damaged parts immediately.
• Do not repair high pressure couplings; you must replace the entire hose.
MOVING PARTS HAZARD
Moving parts can pinch or amputate your fingers.
• Do not operate the pump with the air motor plates removed.
• Keep clear of all moving parts when starting or operating the pump.
• Before servicing the equipment, follow the Pressure Relief Procedure to prevent the
equipment from starting unexpectedly.
FIRE AND EXPLOSION HAZARD
Improper grounding, poor ventilation, open flames or sparks can cause a hazardous condition
and result in a fire or explosion and serious injury.
• Ground the equipment and the object being lubricated.
• If there is any static sparking or you feel an electric shock while using this equipment, stop
dispensing immediately. Do not use the equipment until you identify and correct the problem.
• Provide fresh air ventilation to avoid the buildup of flammable fumes from solvents or the fluid
dispensed
• Keep the dispensing area free of debris, including solvent, rags, and gasoline.
• Do not smoke in the dispensing area.
GROUNDING AND INSTALLATION
Grounding
WARNING: Before use the pump, check grounding of the whole system to prevent
fire and explosion
To reduce the risk of static sparking, each device should ground effectively.
Pump:
Use a ground wire and clamp as the
Fig.2
. Get rid of the grounding
screw, put the end of the grounding wire into the grounding hole.
Lock the bolt to the pump safety.
Air and Fluid hoses:
Grounding effectively.
Air compressor:
Follow manufacturer's recommendations.
Oil control valve:
Connect the pump with proper grounding wire, always hold a
metal part of the valve firmly to the side of a grounded metal
pail, then trigger the valve.
Barrel:
Use local applicable trolley. If it is metal barrel, put on the
device which is electric, can not put on insulative device
surface, such as paper or carton board which without
grounding.
Other parts:
Operated with local regulation for grounding.
Fluid supply container:
Follow the local code.
Fig.2: Grounding guide
E2
TECHNICAL
DETAILS
EXPLODED AND
PARTS LIST
INSTALLATION
TROUBLE SHOOTING
SAFETY
INSTRUCTIONS
OPERATION
LIMITED
WARRANTY
WALL
INSTALLED
