8
7
This is what the cabinet looks like with the
amp assembly removed. Place the new
amp assembly (part #0005686) where
the old one was. Follow the same steps
as above, but backwards 6 to 1. Power
up the SWA1501 and relish in the fact
that you just replaced an amp assembly.
Hats off to you for a job well done!
6
Three cables need to be removed from
the amp assembly: (1) led PCB cable,
(2) positive (solid yellow) cable, and
(3) negative (yellow and black) cable.
Notice their placement, as well -- solid
yellow cable and black wire of led PCB
cable both towards the edge of the
amp.
Amp assembly replacement continued:
1
3
2
5
It may be easier to remove the amp
assembly if the cabinet is on its side. Do
not completely remove amp assembly
yet, as cables need to be removed fi rst.
Caution:
amp assembly is approximately
15 pounds, so please make sure to grasp
it fi rmly.
8
Important:
The faulty amplifi er
assembly must be returned to LOUD
Technologies. The address should be
on the return shipping label that was
provided with the new amp assembly.
If not, the return address is at the top of
this page. Also, please write the order
number and service request number
(ex: 1046256-1203935) in big, black, bold
numbers on the outside of the box. This
helps expedite the return.
