Owner
’s Manual
7
Owner’s Manual
Bridge Setup
Hookup Diagrams continued...
Now we’re looking at a bridge setup. Instead of the two ins, two outs of the stereo setup, this is a single in, single out.
A cable from the mixer’s left main output jack is connected to the ch. 1 input jack of the MX Series amplifier.
The ch. 1 (bridge) speaker output of the MX amp is then connected to the input of a single passive loudspeaker [Mackie
DRM212-P in this example]. Make sure that the amp mode is set to “bridge”.
48V
MUTE
MUTE
MUTE
MUTE
MUTE
MUTE
MUTE
MUTE
MUTE
Bridge
In bridge mode, only
this gain control is used.
If you have two amplifiers, each could power a
single speaker in bridged mono, to make a very
powerful stereo system. Use a stereo feed from
your mixing console, the left goes to one amp,
and the right goes to the other.
Crossover Cable
Pin 1+ to Pin 1+
Pin 2+ to Pin 1–
COLD
HOT
SPEAKER END
AMPLIFIER END
1+
1–
2–
2+
1+
1–
2–
2+
