Rear Panel Features
and Controls
1. INPUT is a balanced XLR input jack that
accepts mic-level or line-level signals.
2. OUTPUT is a balanced XLR output jack in
parallel with the INPUT jack, allowing the
signal to “loop through” for daisy-chaining
speakers together.
3. LINE/MIC switch for mic-level or line-level
signals at the INPUT.
4. VOLUME control adjusts the input-stage
gain.
5. MUSIC equalization switch ON provides a
low-frequency and high-frequency boost.
6. VOICE equalization switch ON provides a
gentle boost at 3kHz and 6kHz.
7. ON indicator illuminates when the POWER
switch is turned on.
8. LIMITER indicator illuminates when the
limiting protection circuits are activated.
9. POWER switch turns the AC power on and
off.
10. Voltage Select Switch for setting the AC
voltage operation for the voltage being
used.
11. IEC AC Socket. Connect the detachable
power cord to the socket. The protection
fuse is also contained in the AC socket.
CAUTION:
Replace fuse only with the same
type as indicated on the rear panel.
12. Grounding Terminal provides an additional
safety grounding point.
Installation
A 1-3/8" (35mm) socket is provided in the
bottom of the cabinet for mounting the
loudspeaker on a speaker stand.
The ART200A can be suspended with
approved rigging hardware.
Always use at
least two M10 threaded inserts located
on opposite sides of the enclosure.
The
speaker
must
be positioned so that the
weight of the enclosure is equally distributed
over the two inserts.
WARNING:
Never attempt to suspend the
ART Series loudspeakers by their handles.
Consult a professional rigger or structural
engineer prior to suspending loudspeakers
from a structure not intended for that use.
Always know the working load limit of the
structure supporting the loudspeaker array.
Always make sure that the rigging hardware
minimum rating is at least five times the
actual load.
Connections
The XLR connectors use the following AES
standard:
Pin 1 = Ground (Shield)
Pin 2 = Hot (+)
Pin 3 = Cold (–)
INPUT
OUTPUT
VOLUME
MIC
LINE
ON
OFF
ON
OFF
LINE/MIC
MUSIC
VOICE
ON
LIMITER
RISK OF ELECTRIC SHOCK
DO NOT OPEN
REPLACE WITH THE SAME TYPE FUSE AND RATING.
DISCONNECT SUPPLY CORD BEFORE CHANGING FUSE
UTILISE UN FUSIBLE DE RECHANGE DE MÊME TYPE.
DEBRANCHER AVANT DE REMPLACER LE FUSIBLE
WARNING:
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT
EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE. DO NOT REMOVE COVER.
NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED PERSONNEL.
CAUTION
AVIS:
RISQUE DE CHOC ELECTRIQUE — NE PAS OUVRIR
SERIAL NUMBER
MANUFACTURING DATE
THIS APPARATUS
MUST BE GROUNDED
CONCEIVED, DESIGNED, AND MANUFACTURED BY MACKIE INDUSTRIAL • MADE IN ITALY
PATENTS PENDING • COPYRIGHT ©1999 THE FOLLOWING ARE TRADEMARKS /REGISTERED TRADEMARKS
OF MACKIE DESIGN INC.: "MACKIE", "MACKIE INDUSTRIAL", & THE "RUNNING MAN" FIGURE
ART 200A
ACTIVE SPEAKER SYSTEM
