4
STEPS TO INSTALL THE GLIDER SWING
Line up one handle with the bench seat, sliding the
bench end into the notch at the inside centre of the
handle. Align the holes in the handle with the holes
at the end of the bench. Using a flat washer at each
end of the fastening, secure the handle in place with
a hex bolt and lock nut. Tighten the lock nut un l 3
threads of the bolt are visible. Repeat the above for
the second handle at the other side of the bench.
Insert a flat washer and eye bolt into the two
holes on the top of each handle, securing from
underneath with another flat washer and a lock
nut. Secure un l 3 threads are visible beyond the
lock nut, and the eye bolt is perpendicular to the
swing seat.
See figure.
Attaching the
swing chains
Attaching the handles
to the bench
Note:
Make sure
the flat side of
the bench is
at the top.
