17
CHAPTER 7
THE FAILURE PHENOMENON AND SOLUTION
Failure phenomenon
Solution
Failure phenomenon
Pls make sure the PoE module connection is right. POE Port connect with AP, LAN port connect with computer
Can’t land to Wireless
AP through Web page
Pls check the IP address of computer and Wireless AP to see whether they are in same networking segment, The method is
click “start”-“Run” input“cmd” ping 192.168.188.253 to test the Wireless AP connectivity. Reset Wireless AP and load it again;
Pls make sure the IP address 192.168.188.253 is not occupied by other device in Wireless AP’s networking; Check computer
and cable problem, recommend to use 10/100M UTP unshielded cable; Clean up Arp binding from “Start”-“Run” input“cmd”
arp –d Clean the IE Brower’s temporary files and Cache file
Wireless AP can’t
connect with AP
Try to scan the avaliable wireless networking again, Make sure the Wireless AP’s wireless standard 1b/g/n, 2.4G is correct The
Security and passwords are matched between Wireless AP and AP The signal strength of AP is too weak to connect, should be
more than -75dBm
Can’t scan the wireless
AP
Scan it several times more. Make sure there are 5G signal existed. Reset the Wireless AP, scan it again after Wireless AP
restart
The connection of
Wireless AP and AP
is success, but the
computer can’t share
internet
Pls Check the computer’s IP address and DNS setting. If it is dynamin, set the network card as automatically obtain. If it is
static IP, pls contact with ISP for correct IP address and DNS address.
Summary of Contents for WL-APO2G24-061
Page 1: ...CLOUDMANAGED WIFIOUTDOOR ACCESSPOINT300MPBS WL APO2G24 061 USER MANUAL...
Page 2: ...REV 2317...
Page 19: ......
