of upper crossbeam , base crossbeam and table-flap all distribute at both
blade : To adjust left right block 3 , can adjust the space between upper beam
center. According to the spec and thickness workpiece sheet thickness of
over this problem . by screwing down and adjusting nut A to make upper
and base crossbeam both endured and make the interspace protruded
(max-height 0.5mm ) to compensate the distortion. Table-flap jiggles up and
down A , B makes it balanceable. It can guarantee the quality of workpiece .
detours . That will effect the linearity of workpiece . If you make angles of
2. Adjustment of the support capability and folding level degree : The fulcrums
ends of upper . During processing workpiece , it’s hard to avoid definite
both sides suitable, angle of interspace won’t be enough . In order to work
and table-flap S , to make S = 1.3t ( t is thickness ) , to adjust 5 to make upper
machine the user can adjust.
1. Adjustment of the space S between upper crossbeam blade and table-flap
and base blade balanceable , then to lock the bolt . When the space is too
small , the blade wears badly .
Operation Manual
Hand folder
Total P4 No P3
Upper crossbeam and base crossbeam, table-flap make up of the table-flap
structure .When the blade leaves factory , it has been adjusted in gyration
