Mach LightDrive 12, User Manual

Page: 2 / 6

Rev 2002 LightDrive User Guide 2
Basic Operation
1. Connect the LightDrive as shown in the diagram.
2. Apply Power
a. The LightDrive will display a test-pattern, then become ready after 1 second.
b. If no signal is present, the LightDrive will enable all outputs at 100%
OR
display the last pattern
that was active when the User Button was last pressed.
3. Verify LED Lights according to table below:
4. Begin Controlling outputs using your chosen input type
Color Meaning
Yellow Flash Idle – No signals detected. Displaying Last Output.
Yellow Steady Standby – Press Button to Turn Outputs On/Off
Green Flash Running on PWM Input.
Blue Flash Running on Serial Input.
Purple Flash Running on CAN Input.
Red Flash Running at Limit. At least 1 channel >5A.
Red Solid Tripped. Overload/Short on at least one channel.
Auto-reset in 3 seconds.
+12V CANL CANH COM
User
Pushbutton
LED Outputs
R/C PWM Inputs
SIG
+5
COM
+12V G R B
Serial Input
Data In
Data Out
COM
Signal
N/C
COM
Onboard
LED
+12V G R B +12V G R B +12V G R B
1 2