215953
43
Revision A
3.3.3
Programming One-Touch-Return
The One-Touch-Return switches A, B, and C always save header height settings, but swath compressor settings can also be
saved depending on the header type.
To program the One-Touch-Return switches, follow these steps:
1022042
Figure 3.23: Ground Speed Lever (GSL)
1.
Adjust the header and swath compressor to desired
position.
2.
Press and hold switch A, B, or C on the ground speed lever
(GSL) handle for 3 seconds until an audible tone is heard.
The current header/swath compressor settings are saved to
that switch. To return header to a preset condition, quickly
tap the A, B, or C switch.
NOTE:
A new swath compressor setting will only be stored if the
compressor position was set with the UP/DOWN switches
on the console. If swath compressor height sensor is
disabled, automation is disabled. Raise/lower operation is
only possible by pressing console switches.
3.3.4
Adjusting Compression
The swath compressor automatically raises when the load on the shield exceeds the compression setting. When load
decreases, the compressor deck automatically returns to the target height.
The compression setting is set at the factory to suit most crop conditions and can be adjusted as follows:
1021903
A
B
Figure 3.24: Compression Adjustment
1.
Loosen jam nut (A) to allow adjustment knob (B) to turn.
Do
NOT
remove the nut.
•
For a more compact windrow with higher wind
resistance, turn adjuster knob (B) clockwise to increase
cut crop compression.
•
To minimize crop shelling and decrease cut crop
compression, turn adjuster knob (B) counterclockwise.
NOTE:
Start with the lowest compression (with the adjuster knob
fully turned counterclockwise) and increase the
compression setting in 1/2 turn increments as required.
2.
Tighten jam nut (A) sufficiently to maintain the setting.
