MacDon R116, Unloading And Assembly Instructions

Page: 81 / 234

214713
73
Revision A
4.4 Installing Hitch Swing Cylinder
1011322
A
B
C
Figure 4.43: Steering Cylinder
1. Remove the banding (A) securing the hitch swing
cylinder (B) to the hitch.
2. Remove pin (C) securing cylinder (B) to hitch.
1011502
A
B
C
D
Figure 4.44: Hitch Swing Cylinder
3. Disconnect the hoses from the cylinder and cap off
openings on cylinder and hoses.
4. Reposition cylinder (A) at right side of hitch. Use pin (C)
to attach barrel end to lug (B). Secure with cotter
pin (D).
NOTE:
The clevis end of cylinder will be attached to the Road
Friendly Transport
™
system casting after the system is
primed. Refer to 5.5 Priming the Hitch Swing Cylinder,
page 102 .
5. Turn the valve on the hitch swing cylinder 180 degrees,
so that fittings are pointing up.
ASSEMBLING THE DISC MOWER (FACTORY-INSTALLED TRANSPORT)