MacDon R116, Unloading And Assembly Instructions

Page: 17 / 234

214713
9
Revision A
Chapter 3: Assembling the Disc Mower (With or Without
the Dealer-Installed Transport)
Perform the following procedures in the order provided to assemble the disc mower without the transport system, or
when the Road Friendly Transport
™
will be installed by the Dealer.
To assemble a disc mower with the factory-installed transport, refer to 4 Assembling the Disc Mower (Factory-
Installed Transport), page 57 .
3.1 Repositioning Center-Link Top Anchor
Perform this procedure to reposition the center-link top anchor into working position.
1011354
A
B
C
Figure 3.1: Carrier
1. Place forklift forks (B) under top beam and lift carrier
frame (A) slightly until pin at base of center-link anchor
is loose. Use a piece of wood (C) to protect paint
on frame.
1011500
A
B
Figure 3.2: Float Spring
2. Loosen jam nut (A) and fully loosen float spring bolt (B).
Repeat on the opposite side.