MacDon R113 SP, Operator'S Manual

Page: 207 / 240

215009
193
Revision A
4.11.2 Replacing Amber Hazard/Signal Light Fixture
WARNING
To avoid bodily injury or death from unexpected startup of machine, always stop the engine and remove the key from
the ignition before leaving the operator
’
s seat for any reason.
1. Lower header fully.
2. Shut down the engine, and remove the key from the ignition.
1027279
A
A
B
Figure 4.199: Amber Hazard Light
3. Remove four nuts (A) and bolts (B) (only three shown)
securing the light to the bracket, and remove light.
Disconnect the light from the electrical harness.
4. Connect the new light to the electrical harness.
5. Position the new light on bracket with bolts (B), and install
and tighten four nuts (A).
6. Check operation of the new light.
4.11.3 Replacing Amber Hazard/Signal Bulb
WARNING
To avoid bodily injury or death from unexpected startup of machine, always stop the engine and remove the key from
the ignition before leaving the operator
’
s seat for any reason.
1. Lower the header fully.
2. Shut down the engine, and remove the key from the ignition.
1021281
A
Figure 4.200: Plastic Lens and Screws
3. Remove two Phillips screws (A) from the fixture, and
remove the plastic lens.
4. Replace the bulb (trade #1157), and reinstall plastic the lens
and screws.
MAINTENANCE AND SERVICING