215333
192
Revision A
1024932
A
Figure 4.130: Driveline
10. Slide driveline (A) downwards, tilt it to the side, and pull
driveline up and out of drum.
NOTE:
For clarity, illustration shows a cutaway view of drum and
tube shield.
1027275
A
B
Figure 4.131: Driven Drum
11. Use an 18 mm deep socket to remove four M12 bolts (A)
and washers holding the drum disc in place.
12. Remove drum disc assembly (B).
Installing Small Driven Drum and Driveline
–
R116 PT
WARNING
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and remove the key
from the ignition before leaving the operator
’
s seat for any reason.
WARNING
Exercise caution when working around the blades. Blades are sharp and can cause serious injury. Wear gloves when
handling blades.
NOTE:
Illustrations show left drum and driveline.
1.
Lower the rotary disc pull-type fully.
2.
Shut down the engine, and remove the key from the ignition.
