MacDon R1 Series, Operator'S Manual

Page: 143 / 346

215333
127
Revision A
4.3.2 Break-In Inspections
Table 4.1 Break-In Inspection Schedule
Inspection
Interval
Item
Refer to
1
Hour
Check wheel bolts Checking Wheel Bolts, page 270
1
Hour
Check clutch operation and slippage Checking Clutch Operation, page 241
5
Hours
Check for loose hardware and tighten
to required torque
7.1 Torque Specifications, page 309
5
Hours
Check conditioner drive belt tension Inspecting Conditioner Drive Belt, page 254
25
Hours
Check drive belt tension Inspecting Conditioner Drive Belt, page 254
25
Hours
Check driveline taper pin torque 4.5.8 Inspecting Driveline Taper Pins, page 248
50
Hours
Check conditioner drive belt tension Inspecting Conditioner Drive Belt, page 254
50
Hours
Check cutterbar lubricant 4.4.3 Lubricating Cutterbar, page 146
50
Hours
Check and change conditioner roll
timing gearbox lubricant
4.5.11 Conditioner Roll Timing Gearbox , page 258
50
Hours
Check and change swivel gearbox
lubricant
4.5.13 Header Swivel Gearbox and Hitch Swivel Gearbox, page 267
50
Hours
Check and change pull-type drive
gearbox lubricant
4.5.12 Pull-Type Drive Gearbox (T-Gearbox), page 260
250
Hours
Check and change swivel gearbox
lubricant
4.5.13 Header Swivel Gearbox and Hitch Swivel Gearbox, page 267
250
Hours
Check and change pull-type drive
gearbox lubricant
4.5.12 Pull-Type Drive Gearbox (T-Gearbox), page 260
4.3.3 Preseason Servicing
CAUTION
•
Review the operator's manual to refresh your memory on safety and operating recommendations.
•
Review all safety signs and other decals on the rotary disc pull-type and note hazard areas.
•
Ensure all shields and guards are properly installed and secured. Never alter or remove safety equipment.
•
Make certain you understand and have practiced safe use of all controls. Know the capacity and the operating
characteristics of the machine.
•
Check the first aid kit and fire extinguisher. Know where they are and how to use them.
Perform the following procedures at the beginning of each operating season:
1. Lubricate machine completely. For instructions, refer to 4.3.5 Lubricating the Rotary Disc Pull-Type, page 128 and 4.4.3
Lubricating Cutterbar, page 146 .
2. Check tire pressure and adjust as required. For information, refer to Inflating Tires, page 273 .
MAINTENANCE AND SERVICING