215333
241
Revision A
1019432
A
Figure 4.244: R116 PT Clutch Driveline
1010777
A
B
C
Figure 4.245: Driveline Shield Cone
14. Slide shield cone onto metal plate (C) attached to center
support, secure with two lever clamps (A), and hook safety
chain (B) to hitch.
IMPORTANT:
If installing a replacement guard, ensure chain (B) is short
enough that it does
NOT
wrap around the driveline guard.
Checking Clutch Operation
The driveline clutch requires an initial break-in procedure otherwise the clutch may slip prematurely. As part of the break-
in procedure, the clutch spring pressure should be released and the header engaged. This intentional slippage of the clutch
will wear in and seat the friction linings against the metal drive plates and remove any oxidization.
Perform the following run-in procedure during the rotary disc pull-type
’
s initial break-in, whenever the clutch friction
linings have been replaced, or when the unit has not been operated for 6 months or more.
WARNING
To avoid injury or death from unexpected start-up of machine, always stop the engine and remove the key from the
ignition before leaving the operator
’
s seat for any reason.