MacDon PW8, Unloading And Assembly Instructions

Page: 101 / 170

214658
93
Revision A
Setting Preset Cutting Height (Case 7010/8010, 7120/8120/9120, 7230/8230/9230,
7240/8240/9240)
To set preset cutting height, follow these steps:
NOTE:
Changes may have been made to the combine controls or display since this document was published. Refer to the
combine operator
’
s manual for updates.
CAUTION
Check to be sure all bystanders have cleared the area.
1023375
A
B
C
D
E
Figure 6.45: Case Combine Controls
A - Set #1 Switch B - Set #2 Switch
C - Header Height Mode Light D - Header Height Mode Light
E - Fine Adjust Switch
1. Engage the separator and header.
2. Manually raise or lower the header to the desired
cutting height.
3. Press SET #1 switch (A). The HEADER HEIGHT
MODE light (C) (next to SET #1 switch) turns on.
4. Manually raise or lower the header to a second desired
cutting height.
5. Press SET #2 switch (B). The HEADER HEIGHT
MODE light (D) (next to SET #2 switch) turns on.
1014910
A
Figure 6.46: Case Combine Controls
6. To swap between set points, press HEADER
RESUME (A).
7. To pick up header at headlands, press HEADER
RESUME (A) twice. To lower, press HEADER
RESUME (A).
NOTE:
You can adjust these set points by using FINE ADJUST
switch (E) in Figure
6.45, page 93 .
NOTE:
Pressing the HEADER RAISE/LOWER switch will
disengage AUTO HEIGHT mode. Press HEADER
RESUME to re-engage.
PREDELIVERY INSPECTION