MacDon PW8, Operator'S Manual

Page: 269 / 304

214657
255
Revision A
5.10.2 Adjusting Draper Speed Sensor
The draper speed sensor position is factory-set, but it may require adjustment if problems occur with the draper
speed system or when replacing sensor components. Check the draper speed sensor position prior to making any
adjustments. Refer to
5.10.1 Checking Draper Speed Sensor Position, page 254 .
DANGER
To avoid bodily injury or death from unexpected startup of machine, always stop engine and remove key
from ignition before leaving operator
’
s seat for any reason.
1. Lower header to the ground, and lower the hold-down completely.
2. Stop the engine, and remove the key from the ignition.
Figure 5.204: Draper Speed Sensor
3. Hold sensor (B) with a wrench and loosen jam nut (C).
4. Turn jam nuts (C) and (A) to achieve the required
sensor to disc clearance.
5. Tighten jam nuts (C) and (A).
MAINTENANCE AND SERVICING