MacDon PW8, Operator'S Manual

Page: 260 / 304

214657
246
Revision A
Installing Slave Cylinder
Figure 5.183: Right Side Slave Cylinder
1. Remove the 45 degree elbow (A) from the previously
removed slave cylinder. Refer to
Removing Slave
Cylinder, page 244 .
2. Remove plug from new slave cylinder port.
3. Install elbow (A) onto new slave cylinder as shown.
Ensure fitting is in line with cylinder, and tighten jam nut
on elbow.
Figure 5.184: Right Side Slave Cylinder
4. Connect hose (A) from master cylinder to elbow (B),
and tighten fitting.
Figure 5.185: Right Side Slave Cylinder
5. Position rod end of cylinder (A) and safety prop into
cylinder support bracket, and secure with the shorter
clevis pin (B). Ensure clevis pin head faces outboard.
6. Secure clevis pin (B) with washer and cotter pin
(not shown).
7. Lift hold-down arm (C) until clevis pin (D) can be
installed through lift arm and barrel end of cylinder.
Ensure clevis pin head faces outboard.
8. Secure clevis pin (D) with washer and cotter pin
(not shown).
9. Remove block of wood inserted in Removing Slave Cylinder, page 244 .
10. Bleed cylinders and lines. Refer to 5.9.4 Bleeding Cylinders and Lines, page 247 .
MAINTENANCE AND SERVICING