![background image](http://html2.mh-extra.com/html/macdon/pw8/pw8_operators-manual_3429414111.webp)
214657
97
Revision A
Removing Header Height Sensor Assembly (Left Side)
DANGER
To avoid bodily injury or death from unexpected startup of machine, always stop engine and remove key
from ignition before leaving operator
’
s seat for any reason.
1.
Lower header to ground, shut down combine, and remove key from ignition.
2.
Open left endshield. Refer to
3.3.1 Opening Left Endshield, page 29
.
Figure 4.3: Header Height Sensor Assembly
–
Left Side
3.
Disconnect wire harness (A).
4.
Push up on rod end clip (B). Slide linkage rod (C) out of
rod end clip (B).
Figure 4.4: Header Height Sensor Assembly
–
Left Side
5.
Remove nuts and bolts (A).
6.
Remove sensor (B) and control arm (C).
NOTE:
Note orientation of control arm, this will be required for
reassembly.
Summary of Contents for PW8
