MAC215990
41
Revision A
1028865
A
B
Figure 3.12: Left Header Endshield
3.
While closing the endshield, ensure header endshield (A)
does not contact the top of endsheet (B). If adjustment is
required, refer to
.
IMPORTANT:
The aluminum endsheet will be damaged if the weight of
the plastic endshield rests on it.
C
1028867
A
B
Figure 3.13: Left Header Endshield
4.
Insert the front of the header endshield behind hinge
tab (B) and into the divider cone.
5.
Swing the header endshield in direction (A) into the closed
position. Engage two-stage latch (C) with a firm push.
A
B
1028858
Figure 3.14: Two-Stage Latch
IMPORTANT:
Check that the header endshield is locked. Ensure bolt (A) is
fully engaged on two-stage latch (B) to prevent the header
endshield from opening while operating the header. If
adjustment is required, refer to
NOTE:
The header endshield is transparent in the illustration to
show the latch.
Checking and Adjusting Header Endshields
Header endshields are subject to expansion or contraction caused by large temperature variations. The position of the
header endshield can be adjusted to compensate for dimensional changes.
IMPORTANT:
The aluminum endsheet will be damaged if the weight of the plastic header endshield rests on it.
