MAC215990
419
Revision A
1031439
B
A
C
Figure 4.340: Reel Endshields
–
Inboard Tail End
11. Position new reel endshield (A) as shown. Insert the
endshield tab into neighboring endshield (B).
12. Position the other end of new endshield (A) on the tine
tube. Secure the endshield with bushing (C).
1031440
A
B
C
D
Figure 4.341: Reel Endshields
–
Inboard Tail End
13. Position tail end finger (A) as shown.
14. Secure tail end finger (A) and the bushing (installed in Step
) with M10 bolt (B), end finger retainer (C),
and nut (D).
1031434
C
A
B
B
Figure 4.342: Reel Endshields
–
Inboard Tail End
15. Rotate reel endshield (A) upward. Engage tabs (B) on
both ends.
16. Secure the reel endshields using six M10 screws and
nuts (C).
17. Torque nuts (C) to 35 Nm (26 lbf·ft).
IMPORTANT:
Do
NOT
overtighten the nuts.
Replacing Reel Endshield Supports
The reel endshield supports need to be replaced if they are damaged.
DANGER
To prevent injury or death from the unexpected start-up of the machine, always stop the engine and remove the key
from the ignition before leaving the operator
’
s seat for any reason.
