MAC215990
401
Revision A
1001283
A
Figure 4.293: Bushing Clamp
7.
Release bushing clamps (A) using a small screwdriver to
separate the serrations. Pull the clamp off the tine tube.
1004617
A
B
Figure 4.294: Bushing
8.
Rotate tine tube arm (A) until clear of the disc and slide the
arm inboard off of bushing (B).
9.
Remove bushing halves (B). If necessary, remove the next
finger, so that the arm can slide off of the bushing. Refer to
the following procedures as needed:
•
Removing Plastic Fingers, page 398
•
Removing Steel Fingers, page 396
Cam end bushings
1004613
A
Figure 4.295: Cam End
10. Remove the endshields and endshield support (A) from the
applicable tine tube location on the cam end.
NOTE:
Removing cam end bushings requires the tine tube to be
moved through the disc arms to expose the bushing.
