MAC215990
383
Revision A
1032009
A
Figure 4.261: Draper Tensioner
5.
Tighten the draper by turning adjuster bolt (A) clockwise.
For instructions, refer to
6.
Disengage the reel and header safety props.
DANGER
Ensure that all bystanders have cleared the area.
7.
Start the engine.
8.
Fully lower the header and the reel.
9.
Engage the header. Ensure that the side drapers track
correctly. For instructions on adjusting the drapers, refer to
4.12.4 Adjusting Side Draper Tension, page 375
.
4.12.10 Removing Side Draper Drive Roller
The side draper deck has a roller on either end of the deck. One is the idler roller and one is the drive roller.
DANGER
To prevent injury or death from the unexpected start-up or fall of a raised machine, always stop the engine and remove
the key from the ignition before leaving the operator
’
s seat or making adjustments to the machine. Never work on or
beneath an unsupported header. If the header is fully raised, always engage the safety props. If the header is off of the
ground but not raised to its full height, place blocks under the header.
DANGER
Ensure that all bystanders have cleared the area.
1.
Start the engine.
2.
Raise the header fully.
3.
Raise the reel fully.
4.
If the draper connector is not visible, engage the header until the connector is accessible at the outboard end of
the deck.
5.
Shut down the engine, and remove the key from the ignition.
6.
Engage the reel safety props. For instructions, refer to
Engaging Reel Safety Props, page 37
.
7.
Engage the header safety props. For instructions, refer to the combine operator
’
s manual.
