MAC215990
301
Revision A
Installing Feed Auger Fingers
The feed auger has fingers that extend and retract to pull crop into the feeder house on the combine. Fingers may need to
be installed onto the auger drum to change its configuration profile.
DANGER
To prevent bodily injury or death from the unexpected start-up of the machine, always stop the engine and remove the
key from the ignition before making adjustments to the machine.
WARNING
Ensure that all bystanders have cleared the area.
WARNING
To prevent bodily injury from the fall of a raised reel, always engage the reel safety props before going under the
raised reel for any reason.
IMPORTANT:
When installing additional fingers, ensure you install an equal number on each side of the auger.
1.
Raise the reel fully.
2.
Shut down the engine, and remove the key from the ignition.
3.
Engage the reel safety props. For instructions, refer to
Engaging Reel Safety Props, page 37
.
1019338
B
A
Figure 4.105: Auger Access Hole Cover
4.
Remove bolts (A) and access cover (B) closest to the finger
you are removing. Retain the parts for reinstallation.
