MAC215990
296
Revision A
1018813
A
Figure 4.94: Blocks under the Auger
14. Remove wooden blocks (A) from the feed draper.
4.7.5
Adjusting Feed Auger Drive Chain Tension
The auger is chain-driven by the float module drive system sprocket attached to the side of the auger. Insufficient chain
tension can prematurely wear sprockets or damage the chain.
DANGER
To prevent injury or death from the unexpected start-up of the machine, always stop the engine and remove the key
from the ignition before leaving the operator
’
s seat for any reason.
WARNING
To prevent bodily injury from the fall of a raised reel, always engage the reel safety props before going under the
raised reel for any reason.
WARNING
Ensure that all bystanders have cleared the area.
1.
Start the engine. For instructions, refer to the combine operator
’
s manual.
2.
Lower the header fully.
3.
Raise the reel fully.
4.
Engage the reel safety props. For instructions, refer to
Engaging Reel Safety Props, page 37
.
5.
Detach the header from the combine. For instructions, refer to
3.6 Header Attachment/Detachment, page 55
6.
Shut down the engine, and remove the key from the ignition.
