262171
259
Revision A
5.5.7
Adjusting Draper Speed
Draper speed is displayed in mph or km/h (depending on the global units selection). The draper speed adjustment can be
set to auto or manual mode.
•
AUTO mode: Draper speed is maintained relative to ground speed. For instructions, refer to
.
•
MANUAL mode: Draper speed is manually set and is maintained independently of ground speed. For instructions, refer
to
Setting Draper Speed in Manual Mode, page 260
.
NOTE:
Both speed modes work with the One-Touch-Return feature. For example, button A on the ground speed lever (GSL) can
be set for MANUAL mode and button B can be set for AUTO mode. For instructions, refer to
.
Setting Draper Speed in Auto Mode
This adjustment requires the header to be engaged. The instructions in this section show you how to set the draper speed
in auto mode using the HarvestTouch
™
Display.
ϭϬϰϮϬϱϵ
A
Figure 5.137: HarvestTouch
™
Display - Header Run
Screen
1.
Engage the header to display header run screen 1 or 2, and
then press DRAPER SETTINGS icon (A).
ϭϬϰϮϬϲϯ
A
B
C
Figure 5.138: Draper Adjust Page
2.
Set AUTO switch (A) to the ON position to access the
following auto draper speed parameters:
•
Minimum draper speed (B)
•
Draper speed index (C)
NOTE:
These settings are grayed-out in manual mode.
3.
To set the minimum draper speed, press arrows (B) beside
MINIMUM DRAPER SPEED and select a value within the
adjustment range: (1.6
–
8 km/h [1
–
5 mph]). The default is
5 km/h (3.0 mph).
NOTE:
When AUTO mode is on, the speed is displayed in km/h or
mph and cannot be changed.
