262171
258
Revision A
1019559
A
Figure 5.134: GSL
4.
Use reel speed switches (A) on ground speed lever (GSL) to
set reel speed. The desired speed increases 1 rpm (or
0.1 mph or 0.2 km/h) per momentary press, or continuous
scrolling if switch is pressed and held.
Adjusting Reel Pressure Alarm
The reel pressure alarm alerts the Operator that the reel is operating above the desired pressure. A lower setting will cause
the alarm to be set off more often; a higher setting will allow the alarm to be set off less frequently. This adjustment
requires that the header be engaged.
ϭϬϰϮϬϰϱ
A
Figure 5.135: HarvestTouch
™
Display - Header
Run Screen
1.
Engage the header to display header run screen 1 or 2.
2.
To adjust the reel pressure alarm set point, press REEL
SETTINGS icon (A) to access the REEL ADJUST page.
ϭϬϰϮϬϱϭ
A
Figure 5.136: Reel Adjust Page
3.
Press set point arrows (A) to set the desired pressure point
that will trigger the alarm.
NOTE:
The factory setting is 200 bar (2900 psi). Adjusting past the
highest setting turns the alarm off.
