MacDon M205, Operator'S Manual

Page: 102 / 514

214603
82
Revision A
Display (Lower or Upper Line) Description
LOAD|
■■■■
| | ####
Bar graph representing hydraulic operating pressure. Full
scale is preprogrammed overload pressure (2500
–
5000 psi). If sensor disabled, LOAD does not display 7
### °C or F HYD OIL TEMP
### °C or F HYD TEMP
Hydraulic oil temperature
Sensor disabled. TEMP and SENSOR alternate at
1 second intervals
##.# VOLTS Engine electrical system operating voltage
##.# SWATH COMPR HT
SWATH CO SENSOR Swath compressor height (00.0
–
10.0); fully raised is 0
Sensor disabled
SCROLL
SUB-MENU (lower line only)
#### KNIFE SPEED
##.# HEADER HEIGHT
LOAD|
■■■■
|
■■■■
| ####
Displays sub-menu after two to three seconds. Press
SELECT to cancel. Scroll through sub-menu display with
CDM switch
Cab-Forward, Engine Running, Header Engaged, Draper Header, Index Switch OFF
Scroll through display with cab display module (CDM) switch or ground speed lever (GSL) switch.
Display (Lower or Upper Line) Description
#####.# ENGINE HRS Total engine operating time
#####.# UNIT HRS Total windrower operating time
#####.# HEADER HRS Total header operating time
##.# ACRES/HOUR
##.# HECTARES/HOUR (if metric)
Actual cutting rate in acres (hectares)/hour
###.# SUB ACRES
###.# SUB HECTARES (if metric) Area cut since last reset. To reset, display SUB ACRES on lower line,
and hold down PROGRAM switch until display resets (5 to 7 seconds)
###### TOTAL ACRES
###### TOTAL HECT (if metric)
Total area cut by machine
##.## REEL MPH
##.## REEL KPH (if metric)
##.## REEL SENSOR (flashing) Reel peripheral speed
Sensor disabled. MPH or KPH and SENSOR alternate at 1 second
intervals
##.# DRAPER SPEED Draper speed (0.0
–
11.0)
#### KNIFE SPEED
#### KNIFE SENSOR Knife speed In strokes per minute
Sensor disabled. SPEED and SENSOR alternate at 1 second intervals
##.# HEADER HEIGHT
##.# HEADER SENSOR Distance setting (00.0
–
10.0) between cutterbar and ground
Sensor disabled. HEIGHT and SENSOR alternate at 1 second intervals
##.# HEADER ANGLE
##.# HEADER SENSOR Angle setting (00.0
–
10.0). Header relative to ground
Sensor disabled. ANGLE and SENSOR alternate at 1 second intervals
OPERATOR
’
S STATION
7. The LOAD sensor to monitor knife/conditioner circuit pressure is optional. To monitor reel/auger circuit
pressure, relocate sensor as per kit instruction MD #169031, which is available through your Dealer.