215794
75
Revision A
1.
Turn the ignition key to RUN, or start the engine.
1011760
CXXX
EXXX
WINDROWER SETUP?
NO/YES
A
B
C
Figure 5.39: CDM Programming Buttons
2.
Press PROGRAM (A) and SELECT (C) on the CDM to enter
programming mode.
•
WINDROWER SETUP? is displayed on the upper line.
•
NO/YES is displayed on the lower line.
3.
Press right arrow (B) to select YES. Press SELECT (C).
•
SET KNIFE SPEED? is displayed.
1011813
CXXX
EXXX
HDR CUT WIDTH? 0101
20.5 FEET
D
C
B
A
Figure 5.40: Header Cut Width
4.
Press SELECT (D) until HDR CUT WIDTH? #### is displayed
on the upper line.
•
Previous cutting width is displayed on the lower line.
5.
Press left arrow (B) or right arrow (C) to change the header
cut width. Press SELECT (D).
6.
Press PROGRAM (A) to exit programming mode or press
SELECT (D) to proceed to next WINDROWER SETUP action.
5.3.12
Activating Swath Compressor
An optional swath compressor (MD #C2061) is available. Before the swath compressor can be used, it must be activated in
the cab display module (CDM).
NOTE:
•
CDM5 (version 512 or later) and WCM2 (version 237 or later), or WCM3 (version 116 or later), are required to operate
the swath compressor.
•
The Double Windrow Attachment (DWA) system must be disabled in the CDM when setting up the swath compressor.
•
Users can activate and set up the swath compressor via in-cab controls without a header attached to the windrower.
CAUTION
Check to be sure all bystanders have cleared the area.
