215794
65
Revision A
5.3
Configuring Windrower
The Operator can configure several windrower, header, and other attachment performance options using the cab display
module (CDM).
5.3.1
Setting Header Knife Speed
The speed of the knife on non-rotary headers can be set by accessing the cab display module
’
s (CDM) SET KNIFE SPEED
sub-menu, in the WINDROWER SETUP menu.
NOTE:
The header
MUST
be physically attached and hydraulically and electrically connected to the windrower before the
Operator can perform this procedure. The CDM automatically adjusts its programming for each header.
1011760
CXXX
EXXX
WINDROWER SETUP?
NO/YES
A
B
C
Figure 5.17: CDM Programming Buttons
1.
Turn the ignition key to the RUN position, or start the
engine.
2.
Press PROGRAM (A) and SELECT (C) simultaneously on the
CDM to enter programming mode.
•
WINDROWER SETUP? will appear on the upper line.
•
NO/YES will appear on the lower line.
3.
Press right arrow (B) to select YES. Press SELECT (C).
•
SET KNIFE SPEED? will appear.
•
The current knife speed will appear on the lower line.
1011803
CXXX
EXXX
SET KNIFE SPEED
#### SPM
D
C
B
A
Figure 5.18: Knife Speed Setting
4.
Press left arrow (B) or right arrow (C) to select knife speed.
Press SELECT (D).
5.
Press PROGRAM (A) to exit programming mode or press
SELECT (D) to proceed to the next WINDROWER SETUP
action.
