215015
172
Revision A
1000753
A
B
C
D
Figure 6.3: Header Boot
2.
Position boot (B) onto lift linkage (A) and reinstall pin (C).
Pin may be installed from either side of boot.
3.
Secure pin (C) with hairpin (D).
4.
Repeat for opposite side.
6.1.2
Attaching a D Series or D1 Series Header
D50, D60, D65, and D1 SP headers can be attached to an M155 Self-Propelled Windrower.
1008824
Figure 6.4: M155 Draper Header Hydraulics
The M155 Self-Propelled Windrower is factory-equipped to run
a D/D1 Series Draper Header.
If installing an HC10 Hay Conditioner, Reverser kit (MD #B4656)
is recommended. If necessary, obtain the recommended kit and
install it in accordance with the instructions supplied with
the kit.
Refer to the following instructions based on the type of center-
link installed on your windrower:
•
Attaching a D Series or D1 Series Header: Hydraulic Center-
Link with Optional Self-Alignment, page 172
•
Attaching a D Series or D1 Series Header: Hydraulic Center-
Link without Self-Alignment, page 178
•
Attaching a D Series or D1 Series Header: Mechanical
Attaching a D Series or D1 Series Header: Hydraulic Center-Link with Optional Self-Alignment
NOTE:
Draper header boots must be installed onto the windrower lift linkage before starting this procedure. Refer to
Attaching Header Boots, page 171
WARNING
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and remove the key
from the ignition before leaving the operator
’
s seat for any reason.
