215676
216
Revision A
4.5.2
Attaching D or D1 Series Draper Header
The procedure for attaching a D or D1 Series Draper Header to the windrower differs slightly depending on the
configuration of the windrower. Proceed to the relevant topic:
•
Attaching D or D1 Series Draper Header
Hydraulic Center-Link with Self-Alignment, page 216
•
Attaching D or D1 Series Draper Header
Hydraulic Center-Link without Self-Alignment, page 221
•
Attaching D or D1 Series Draper Header
Mechanical Center-Link, page 227
Attaching D or D1 Series Draper Header
–
Hydraulic Center-Link with Self-Alignment
The windrower may be equipped with an optional self-aligning hydraulic center-link, which allows the Operator to control
the vertical position of the center-link from the cab.
NOTE:
Draper header boots must be installed onto the windrower lift linkage before beginning this procedure. For instructions,
refer to
4.5.1 Attaching Header Boots, page 215
.
DANGER
To prevent bodily injury or death from the unexpected startup of the machine, always stop the engine and remove the
key from the ignition before leaving the operator
’
s seat for any reason.
1.
Shut down the engine, and remove the key from the ignition.
1000754
A
B
Figure 4.108: Header Leg
2.
Remove hairpin (A) from pins (B), and remove the pins from
both header legs.
1008925
A
Figure 4.109: Ground Speed Lever
DANGER
Ensure that all bystanders have cleared the area.
3.
Start the engine and activate HEADER DOWN button (A) on
the ground speed lever (GSL) to fully retract the header lift
cylinders.
IMPORTANT:
Before starting the engine for the first time the windrower
is operated in a season, remove the protective cover from
the exhaust stack.
