215676
204
Revision A
1.
Lower the header to the ground.
2.
Shut down the engine, and remove the key from the ignition.
1002089
A
B
Figure 4.87: Mechanical Center-Link
3.
Loosen nut (A) on the center-link.
•
To increase (steepen) the header angle, rotate barrel (B)
to lengthen the center-link.
•
To decrease (flatten) the header angle, rotate barrel (B)
to shorten the center-link.
4.
Tighten plate nut (A) with a slight tap of a hammer.
Checking Self-Locking Center-Link Hook
Inspect the self-locking center-link hook periodically to ensure it is in good working order.
1000739
A
Figure 4.88: Center-Link
1.
If the header is attached to the windrower, disconnect the
center-link hook from the header by pulling up on
handle (A) to release the locking device and then lifting the
hook off of the header pin.
1000741
A
B
C
Figure 4.89: Center-Link Hook
A - Handle
B - Lock Pin
C - Actuator Rod
2.
Lower handle (A) into the locked position.
3.
Push up on lock pin (B). The handle should catch on the
casting and the pin should
NOT
lift.
