215676
119
Revision A
1009221
CXXX
MXXX
NO/YES
SET CONTROL LOCKS?
B
A
Figure 3.138: Control Locks
4.
Press SELECT (B) until SET CONTROL LOCKS? appears on the
upper line.
•
NO/YES will appear on the lower line.
5.
Press right arrow (A) to select YES. Press SELECT (B).
1009228
CXXX
MXXX
REEL SPEED
ENABLED/LOCKED
D
C
B
A
Figure 3.139: Reel Speed Control Lock
6.
Press SELECT (D) until REEL SPEED appears on the
upper line.
•
ENABLED/LOCKED will appear on the lower line.
7.
Press left arrow (B) to enable the REEL SPEED control
switch.
Press right arrow (C) to lock the REEL SPEED control switch.
8.
Press PROGRAM (A) to exit programming mode, or press
SELECT (D) to proceed to the next WINDROWER SETUP
option.
3.19.10
Displaying Active Cab Display Lockouts
The Operator can generate a list of all windrower features which have been locked out by accessing the cab display
module
’
s (CDM) VIEW CONTROL LOCKS sub-menu.
NOTE:
Displaying header tilt control lock requires installation of the optional Hydraulic Center-Link (MD #B4650).
1009066
CXXX
MXXX
WINDROWER SETUP?
NO/YES
A
B
C
Figure 3.140: CDM Programming Buttons
1.
Turn the ignition key to the RUN position, or start the
engine.
2.
Press PROGRAM (A) and SELECT (C) simultaneously on the
CDM to enter programming mode.
•
WINDROWER SETUP? will appear on the upper line.
•
NO/YES will appear on the lower line.
3.
Press right arrow (B) to select YES. Press SELECT (C).
•
SET KNIFE SPEED? will appear on the upper line.
