215627
47
Revision A
%
$
Figure 4.14: Coolant Recovery Tank Cap and MAX
COLD Fill Line
3.
To add coolant:
remove pressurized cap (A) from the
coolant recovery tank.
4.
Add coolant at a rate not exceeding 11 L/min (3 gpm) until
the recovery tank is half-full and the coolant level is at MAX
COLD line (B).
5.
Replace cap (A).
4.1.7
Checking Engine Gearbox Lubricant Level and Adding Lubricant
Ensure that the lubricant level is correct to maximize the service life of the gearbox components.
$
%
Figure 4.15: Gearbox Lubricant Dipstick
1.
Remove dipstick (A) and check the lubricant level.
$
%
Figure 4.16: Bottom End of Dipstick
2.
If the lubricant level is at or below ADD mark (A) on the
dipstick, remove the breather cap ([B] in Figure
) and add gearbox lubricant. Insert the dipstick again to
check the lubricant level. Repeat this process until the
lubricant level is between ADD mark (A) and FULL mark (B)
on the dipstick.
For lubrication specifications, refer to
and System Capacities, page 145
.
