214735
85
Revision A
4.5.2
D1X or D1XL Series Draper Header
Attaching Draper Header Supports
Draper header supports are required to attach a D1X or D1XL Series Draper Header to the windrower.
WARNING
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and
remove the key from the ignition before leaving the operator
’
s seat for any reason.
If
NOT
installed, attach draper header support (supplied with header) to windrower lift linkage as follows:
1015587
A
B
Figure 4.80: Draper Header Support
1.
Remove hairpin and clevis pin (B) from the draper
header support (A).
1015593
A
B
C
D
Figure 4.81: Draper Header Support
2.
Position the draper header support (B) on lift
linkage (A), and reinstall clevis pin (C).
NOTE:
To avoid pin snagging the windrow, install the clevis pin
on the outboard side of the draper header support.
3.
Secure clevis pin (C) with hairpin (D).
4.
Repeat for opposite lift linkage.