214735
111
Revision A
4.8
Calibrating Windrower Knife Drive on Harvest Performance
Tracker (HPT) Display
NOTE:
Calibration of the knife drive must be completed with the header attached; the header must be engaged to perform
the calibration procedure. If the header is disengaged when calibration is selected, the message ENGAGE
HEADER will appear on the screen.
CAUTION
Check to be sure all bystanders have cleared the area.
1016140
A
B
C
Figure 4.145: Opening the Main Menu
1.
Start the windrower and engage the header.
2.
Press soft key 5 (A) to open the main menu.
3.
Use the HPT scroll knob (B) or the ground speed lever
(GSL) scroll wheel (not shown) to place the red cursor
over the SETTINGS icon (C).
4.
Press the HPT scroll knob (B) or the GSL SELECT
button (not shown) to activate the settings menu
options.
1016143
A
B
Figure 4.146: Windrower Settings Icon and
Calibration Submenu Icon
5.
Scroll to the WINDROWER SETTINGS icon (A) and
press SELECT.
6.
Scroll to the CALIBRATION icon (B), and press
SELECT to open the adjustment page.
NOTE:
The F3 shortcut button on the operator
’
s console will
also open the WINDROWER
’
S SETTINGS menu.
7.
Select KNIFE DRIVE.
