IMPORTANT:
BATTERY IS NEGATIVE GROUNDED. Always connect
starter cable to the positive (+) terminal of battery and
battery ground cable to negative (-) terminal of battery.
Reversed polarity in battery or alternator may result in
permanent damage to electrical system.
9. Attach negative (black) cables (B, D) to negative posts
on batteries, and tighten clamps. Then attach positive
(red) cables (A, C) to positive post on batteries and
tighten clamps.
10. Position plastic covers onto clamps.
11. Close the hood,refer to
Figure 5.59: Battery Terminal Location
Engine Oil
Checking Engine Oil Level
Check engine oil level frequently and watch for any signs of leakage.
To check the engine oil level, follow these steps:
NOTE:
During the break-in period, a higher than usual oil
consumption should be considered normal.
1. Open the hood to the lowest position. Refer to
Opening Hood (Lower Position), page 202
.
2. Operate the engine at low idle, and check for leaks at
the
fi
lter and drain plug.
3. Stop the engine and remove the key.
Wait about
5 minutes.
4. Remove dipstick (A) by turning it counterclockwise
to unlock.
5. Wipe clean, reinsert in engine, and then remove.
Figure 5.60: Engine Oil Level
169890
227
Revision A
Summary of Contents for M105
