MacDon M105, Operator'S Manual

Page: 115 / 384

OPERATION
IMPORTANT:
Caster wheels must be equidistant from center
of windrower.
Figure 4.25: Adjustable Caster Wheels
4. Position bracket (A) and install back bolts (C).
The two shorter bolts are installed at the back inboard
locations.
5. Install bottom bolts (B).
6. Tighten bolts as follows:
a. Snug bottom bolts (B).
b. Tighten and torque back bolts (C) to
330 ft lbf (447 N · m).
c. Tighten and torque bottom bolts (B) to
330 ft lbf (447 N · m).
7. Lower windrower to ground.
IMPORTANT:
Torque bolts after fi rst 5 and 10 hours of operation.
Figure 4.26: Caster Wheel Extensions
4.3.8 Transporting the Windrower
Driving on the Road
WARNING
Collision between windrower and other vehicles may result in injury or death.
WARNING
When driving windrower on public roadways:
• Obey all highway traffic regulations in your area. Use pilot vehicles in front and rear of windrower if
required by law.
• Use slow moving vehicle emblem and flashing warning lights unless prohibited by law.
• If width of attached header impedes other vehicle traffic, remove header and install a MacDon approved
weight box.
169890
101
Revision A