MacDon HC10, Setup, Operation, And Parts Manual

Page: 46 / 186

215593
36
Revision A
$
&
%
'
(
Figure 3.47: Hydraulic Hoses
A - Case Drain B - Conditioner Motor Pressure
C - Deck Motor Return D - Deck Motor Pressure
E - Conditioner Motor Return
12. Connect the five HC10 hydraulic hoses to the header at the
following locations:
•
Hose (A) with small male quick-disconnect from motor
to header
•
Hose (B) with large female quick-disconnect from motor
to header
•
Hose (C) with small female quick-disconnect from deck
to header
•
Hose (D) with small female quick-disconnect from
motor to deck
•
Hose (E) with large female quick-disconnect from
header to motor
3.7.2 Attaching Hydraulics
–
All Headers Except 4.6 m (15 ft.)
Installing hoses, couplers, and fittings included with the HC10 is required to interface header hydraulics.
$
%
&
'
(
)
*
+
Figure 3.48: Hydraulic Coupler Components
–
D Series
Shown, D1 Series Similar
A - Hose Cover B - Coupler Mount
C - Side Draper Return D - Left Draper Case Drain
E - To Side Drapers (Pressure) F - Case Drain Coupler
G - Knife/Conditioner Pressure H - Header Return
1. Remove hose cover (A) from left coupler mount.
2. Disconnect side draper return hose (C) at the main return
tee (refer to item [E] in the figure below).
UNLOADING AND ASSEMBLY