MacDon HC10, Original Instruction

Page: 60 / 242

215126
38
Revision A
3.8 Assembling the Forming Shield
To assemble forming shield, follow these steps:
1. Retrieve the following parts from MD #B4800:
•
Forming shield with baffle, struts, and hardware attached
Retrieve the following parts from the deflector package shipped with MD #B4798:
•
Forming shield deflectors with hardware attached
Retrieve the following parts from the finishing bag shipped with MD #B4798:
•
Deflector fin (left side)
•
Deflector fin (right side)
•
Four smaller deflector fins
Retrieve the following parts from the hardware bag shipped with MD #B4798:
•
Eight 3/8 x 3/4 in. carriage bolts
•
Eight 3/8 in. flange nuts
1005118
A
Figure 3.53: Forming Shield Cover
2. Lay forming shield (A) upside down (flanges of side
supports facing up) on a flat surface.
1005121
A
B
Figure 3.54: Deflector Fins
3. Attach short fins (A) and long fins (B) to the shield using
two 3/8 x 3/4 in. carriage bolts and two 3/8 in. flange nuts
per fin:
•
Assemble short fins (A) to bottom of shield as shown in
illustration at right using hardware provided.
•
Two long fins (B) are handed (outboard and inboard
sides) and should be installed with bolts on outboard
side of the fin. Bolts should be installed with nuts
against the fins.
NOTE:
Fins are only effective for windrows greater than 1778 mm
(70 in.) or if satisfactory formation is not achieved. Store for
future use if not installed.
UNLOADING AND ASSEMBLY