MacDon HC10, Original Instruction

Page: 48 / 242

215126
26
Revision A
3.6 Installing the Conditioner
There are two methods for installing the conditioner. Refer to the following sections for instructions:
•
The lifting method, refer to 3.6.1 Installing Conditioner
–
Lifting Method, page 26
•
The windrower method, refer to 3.6.2 Installing Conditioner
–
Windrower Method, page 28
3.6.1 Installing Conditioner
–
Lifting Method
CAUTION
Equipment used for unloading must meet or exceed the requirements specified below. Using inadequate equipment
may result in vehicle tipping or machine damage.
Table 3.2 Lifting Vehicle Requirements
Minimum Lifting Capacity 2 908 kg (2000 lb.)
Minimum Fork Length 1524 mm (60 in.)
IMPORTANT:
Forklifts are normally rated for a load located 610 mm (24 in.) ahead of back end of the forks. To obtain the forklift
capacity at 1220 mm (48 in.), check with your forklift distributor.
Table 3.3 Lifting Chain Requirements
Chain Type Overhead Lifting Quality (1/2 in.)
Minimum Working Load 2270 kg (5000 lb.)
To install the conditioner using the lifting method, follow these steps:
1002664
A
B
A
Figure 3.24: Conditioner and Lifting Brackets
1. Attach a chain to lifting brackets (A) on the conditioner and
secure chain to lifting device (B).
2. Lift the conditioner to upright position.
3. Remove the shipping blocks if present.
4. Position the conditioner into the header opening from the
rear.
UNLOADING AND ASSEMBLY
2. At 1220 mm (48 in.) from back end of forks.