MacDon HC10, Original Instruction

Page: 239 / 242

215126
217
Revision A
Predelivery Checklist
Perform these checks and adjustments prior to delivery to your Customer. Refer to Unloading and Assembly Instructions
for adjustment details. The completed checklist should be retained either by the Operator or the Dealer.
CAUTION
Carefully follow the instructions given. Be alert for safety-related messages, which bring your attention to hazards and
unsafe practices.
Conditioner Serial Number: _____________________________________________
Table .16 HC10 Hay Conditioner Predelivery Checklist
ü ü
Item Reference
Check for shipping damage or missing parts. Be sure all shipping
material is removed.
—
Check roll drive belt tension.
3.12.1 Checking Roll Drive Belt Tension,
page 47
Check conditioner roll gap, timing, and alignment.
3.12.2 Checking Roll Gap, page 48
and
3.12.3 Checking Roll Timing, page 48
Check rear and side forming shields evenly set to desired position. 3.9 Installing the Forming Shield, page 41
Grease all bearings. 3.11 Lubricating the Conditioner, page 44
Check roll intermesh hardware is securely tightened. 4.9.2 Adjusting Roll Gap, page 68
Check hydraulic hose routing.
4.3 Attaching Hay Conditioner to Header,
page 53
Run-up procedure
3.12.4 Running up the Conditioner, page
49
Check reverse operating mode. Refer to windrower manual.
Check hydraulic hose routing for clearance when raising or lowering
header.
—
Post run-up checks. Stop engine.
—
Check for hydraulic leaks.
—
Check belt drive for alignment and heated bearings. 5.7 Drive Belt, page 81
Check manuals in windrower cab. 3.12.5 Storing Manuals, page 50
Date checked:
Checked by :