MacDon FlexDraper FD1 Series, Unloading And Assembly Instructions

Page: 64 / 354

214685
52
Revision A
Figure 4.48: Left Side of Auger
8. Place new bolt-on flighting (A) outboard of the existing
flighting (B) of the left side of the auger, as shown.
9. Secure with two button head bolts (MD #135723) and
nuts (MD #135799) at location (C).
IMPORTANT:
Ensure bolt heads are on the inboard (crop side) and
nuts are on the outboard side of the flighting.
Figure 4.49: Flighting Stretched Axially
10. Stretch flighting (A) to fit auger tube as shown. Use
slotted holes on flighting to get the best fit around the
auger tube.
Figure 4.50: Flighting on Left Side of Auger
11. With flighting in desired position, mark hole
locations (A) and drill 11 mm (7/16 in.) holes in
auger tube.
12. Remove nearest access cover(s). Retain for
reinstallation.
13. Secure bolt-on flighting on the newly drilled holes (A)
using four flange head bolts and nuts.
14. Repeat Steps 2, page 51 to 13, page 52 for the other
flighting on the left side of the auger.
SETTING UP FLOAT MODULE